From this view, you can vaguely make out the manufacturing supports. These are interesting. Boston Whaler used a rubbery type of foam within these fiberglass inserts to, I surmise, support the two sides of the mold while they poured the urethane foam. Unfortunately, this rubber foam absorbs water like a sponge... they were saturated! These supports also provide some support for the hull in a 10 inch strip up the side of the hull (made out of wood). Perhaps to prevent oil canning?

Click image for maximum view
Date: 08/31/10 - 1:37 PM
Added by: finnwhale
Dimensions: 640 x 480 pixels
Filesize: 90.46Kb
Comments: 0
Number of views: 2312