This is the front face of the seat back with curved portions attached to the upper portion of the straight portions of the seat back. Note that the top most 1x4 is screwed into each curved portion. The second most from the top most 1x4 is screwed into the top most 1x4. Also note, that in the middle portion, I filled in the spacer positions with 1x4s. The reason for this is to allow later curator (via jigsaw) of this portion of the bench back. I basically just thought this looked better than leaving the middle portion of the seat back square.

The next photo will show the rear of the seat back.

Click image for maximum view
Date: 08/08/12 - 7:39 AM
Added by: Ron Mazcko
Dimensions: 960 x 720 pixels
Filesize: 207.42Kb
Comments: 1
Number of views: 2468