The norman pin must pass through the notches within the runners for the key. As shown within this photo, the mount must rotate a bit further until the lower surfaces of the norman pin are above or at the same plane as the upper key runner's lower surface. The width between the notches is only slightly larger than the width of the norman pin. These tight tolerances are designed to minimize the lash within the mount when fully installed. This photo was taken through the slot for key.

Click image for maximum view
Date: 07/30/21 - 2:46 PM
Added by: Schuyler84
Dimensions: 800 x 600 pixels
Filesize: 33.24Kb
Comments: 0
Number of views: 356