A view of rear fuel tank locator/tie down bracket installed. Bracket was mounted using existing holes from O.E.M. tie down hardware. These locations may vary from boat to boat, so I did not supply dimensions for this install. I did not use 5200 to seal and bond this bracket, instead I used the silicone sealant. My reasons for not using the 5200, if I should need to remove the fuel tank for any reason I will need to remove this bracket as well. 5200 tends to create an aggressive and usually permanent bond to fiberglass.

Click image for maximum view
Date: 03/20/10 - 4:12 PM
Added by: dauntless-n-miami
Dimensions: 640 x 480 pixels
Filesize: 44.36Kb
Comments: 0
Number of views: 1739