This photo is the starboard side rail (bottom). You will notice that on the bottom of the 1"x4" piece their are two ss hardware inserts with a threaded shaft. This is where the seat portion of the bench seat screws into the side rails to form either the bench seating position (rear most screw connector) or the fishing platform position (forward most screw connector). These connectors and screws were purchased at Lowes.

Note that the connectors themselves are screwed into the side rail 1"x 4"s to prevent slippage when the screws are tightened.

Later photos will show the screw locations for the seat bench.

Click image for maximum view
Date: 08/29/12 - 4:47 AM
Added by: Ron Mazcko
Dimensions: 850 x 638 pixels
Filesize: 137.83Kb
Comments: 0
Number of views: 2435