1. Use the full 4 digit year for everything you are asking your question about. Example: 1962, 1988, 2000, 2011
2. Include the correct name of your Whaler model. Example: Montauk 17, Montauk 170, Outrage 26, Outrage 260
3. Include the length when necessary. Example: 16, 17, 18, 20, 22
4. Do not post your email address anywhere on this site as it is already in your user profile.

Navigation lights wiring on 22' Outrage
robaguero	#1  Posted on 06/18/07 - 1:35 PM
Member Personal Page Posts: 24 Comments: 1 Joined: 01/22/07	Any of you guys has an idea of how the wiring for the nav lights is routed in the hull?? So far i have only found two leads on starboard side and will try them with the battery to see if it lights up both port and starboard nav lights. Thanks in advance for your help....
Joe Kriz	#2  Posted on 06/18/07 - 2:37 PM
Site Owner Personal Page Personal Album Photo Albums Project Albums Posts: 11447 Comments: 452 Joined: 03/18/05	Rob, The wiring goes out through the starboard side and inside the rubrail to the starboard light. The wires then continue to run around the bow of the boat to the port light. It is easy to remove the rubrail insert if you leave it out in the sun. You don't have to take off the entire rubrail insert. Only remove it where you need to get to the wires. For wiring the switch, see this article: http://www.whalercentral.com/readarti...icle_id=51
robaguero	#3  Posted on 06/18/07 - 6:49 PM
Member Personal Page Posts: 24 Comments: 1 Joined: 01/22/07	As always Joe, you are there with your prompt response.....Thanks a lot, i will try removing the rubrail.