Before Posting, Please Read Our Posting Guidelines Below.
1. Use the full 4 digit year for everything you are asking your question about. Example: 1962, 1988, 2000, 2011 2. Include the correct name of your Whaler model. Example: Montauk 17, Montauk 170, Outrage 26, Outrage 260 3. Include the length when necessary. Example: 16, 17, 18, 20, 22 4. Do not post your email address anywhere on this site as it is already in your user profile.
Hey all,
I have a 17' with a 1995 Evinrude Ocean Pro 90HP on it. My Power tilt cylinder is leaking, and i plan on taking it off and replacing the seals at work. I understand how the unit comes out, but im not sure where the wires for the electric motor on it terminate. I am assuming they go to the relay, but was hoping to find a diagram to confirm (or rather make sure there isn't a connector somewhere else that should be taken apart). Can anyone confirm this for me, or send me a diagram? I like to do all my homework before doing a job so it takes as little time as possible.
Go to http://parts.evinrude.com and select your year in the left column, then the hp, specific model, and then scroll down to power trim tilt hydraulic assy to see the motor. It looks like a pretty long lead so it wouldn't surprise me if it went all the way to the relay box.
Edited by Derwd24 on 12/13/12 - 3:24 PM
Dave - 1983 Outrage 22
I replaced mine this year. 1990 Yamaha 90 HP and the leads run all the way to the terminal block at the rear of the motor. You have to chase them under the oil fill tank. Very straightforward.
Rich
