1. Use the full 4 digit year for everything you are asking your question about. Example: 1962, 1988, 2000, 2011
2. Include the correct name of your Whaler model. Example: Montauk 17, Montauk 170, Outrage 26, Outrage 260
3. Include the length when necessary. Example: 16, 17, 18, 20, 22
4. Do not post your email address anywhere on this site as it is already in your user profile.

installing fuel hose through hull
buckwheat	#1  Posted on 06/09/09 - 11:42 AM
Member Posts: 19 Comments: 2 Joined: 07/10/08	Hello all, hope your doing well. I am slowly turning my 17 sport into a montauk, the next step is to install the 28 gallon fuel tank under the rps. . then running the fuel hose through the hull and out back into the engine. I will be drilling a hole behind the tank, but I need a component to "cap" or "seal" this hole, so that just the hose goes through and not water/waiste. Any ideas guys? buckwheat attached the following image: [33.32Kb]
Guts	#2  Posted on 06/09/09 - 4:18 PM
Member Personal Page Posts: 612 Comments: 8 Joined: 11/21/08	I glassed the hole in mine. The picture you posted looks like a PVE nut for a PVC Drain Tube, inserted in the deck. But I can't tell what is used there.
modenacart	#3  Posted on 06/09/09 - 7:06 PM
Member Personal Page Posts: 741 Comments: 4 Joined: 02/28/09	First, I would be careful using that fuel tank if its fiberglass. Ethanol will break the tank down.
buckwheat	#4  Posted on 06/10/09 - 10:32 AM
Member Posts: 19 Comments: 2 Joined: 07/10/08	it's a plastic tank, I had the fiberglass one and got rid of it cuz ethanol was messing with the motor.