1. Use the full 4 digit year for everything you are asking your question about. Example: 1962, 1988, 2000, 2011
2. Include the correct name of your Whaler model. Example: Montauk 17, Montauk 170, Outrage 26, Outrage 260
3. Include the length when necessary. Example: 16, 17, 18, 20, 22
4. Do not post your email address anywhere on this site as it is already in your user profile.

Hatch support hardware 22' cuddy
mtown	#1  Posted on 06/21/18 - 3:07 PM
Member Personal Page Posts: 613 Comments: 5 Joined: 07/06/08	There is a part of my hatch support hardware that has broken. The best I can describe is it is the sleeve that the support tube travels through. I can send a picture of it if anyone e-mails me. Thanks
Phil T	#2  Posted on 06/22/18 - 7:15 AM
Administrator Personal Page Personal Album Project Albums Posts: 7043 Comments: 6 Joined: 03/26/05	From Mtown: First pic is the parts separated. Second is "assembled". Problem is the round sleeve is broken in two. Phil T attached the following image: [25.66Kb] Edited by Phil T on 06/22/18 - 10:35 AM 1992 Outrage 17 I 2019 E-TEC 90, Viper 17 2+ 2018 Load Rite Elite 18280096VT
Phil T	#3  Posted on 06/22/18 - 7:16 AM
Administrator Personal Page Personal Album Project Albums Posts: 7043 Comments: 6 Joined: 03/26/05	Second Photo: Phil T attached the following image: [23.94Kb] 1992 Outrage 17 I 2019 E-TEC 90, Viper 17 2+ 2018 Load Rite Elite 18280096VT
mtown	#4  Posted on 06/22/18 - 9:27 AM
Member Personal Page Posts: 613 Comments: 5 Joined: 07/06/08	Phil, Thank you for posting. Apparently I sent you the "unassembeled photo twice. I will send you photo #2 which shows the parts together. This photo shows the parts seperated. The part on the left appears intact, but it is the broken piece. I just have the two halves lying together. This part allows the supporting of the cuddy cabin lid in various positions. The SS rod attaches to a similar piece and the "sleeve" has a hole in the side for the "wing bolt" that is pictured. It is a 1989 22' Outrage Cuddy. I am sure the hardware is original. Some how the sleeve split in half, probably from someone trying to force it open or closed when the wing bolt was tight and holding it open or closed. Edited by mtown on 06/22/18 - 9:41 AM
mtown	#5  Posted on 06/22/18 - 10:04 AM
Member Personal Page Posts: 613 Comments: 5 Joined: 07/06/08	This actually looks quite similar. The boat is 50 miles away so I only have part of the entire assembly. https://www.boatoutfitters.com/windsh...d-adjuster Edited by Phil T on 06/22/18 - 10:36 AM