1. Use the full 4 digit year for everything you are asking your question about. Example: 1962, 1988, 2000, 2011
2. Include the correct name of your Whaler model. Example: Montauk 17, Montauk 170, Outrage 26, Outrage 260
3. Include the length when necessary. Example: 16, 17, 18, 20, 22
4. Do not post your email address anywhere on this site as it is already in your user profile.

Looking for Side Rail for a 2000 13' Sport
crabs63	#1  Posted on 04/12/18 - 5:18 AM
Member Posts: 8 Comments: 0 Joined: 11/20/06	A tree came down over the winter and did a number on the side rail on my 2000 13' Sport. I contacted Boston Whaler for a replacement and no lucks. Anyone knows where to find either a used or new one? Thank You! crabs63 attached the following image: [22.68Kb] Edited by crabs63 on 04/12/18 - 5:19 AM
Cvg	#2  Posted on 04/12/18 - 9:27 AM
Member Posts: 32 Comments: 0 Joined: 03/21/18	If you take it to a good local fabricator they should be able to make it like new again. May require a new section to be welded in.
crabs63	#3  Posted on 04/12/18 - 10:27 AM
Member Posts: 8 Comments: 0 Joined: 11/20/06	Cvg, Thank you. Will try that route.
gchuba	#4  Posted on 04/12/18 - 10:30 AM
Member Posts: 1675 Comments: 0 Joined: 03/31/13	That's a welded rail. Not like mine which has fittings where the upper rail attaches to the deck. I can hide welds/seems inside the fitting. A weld will always show. Best you locate a fabricator and use as a template (might have to bring your boat) or find one made for your hull.
max366	#5  Posted on 04/12/18 - 11:11 AM
Member Posts: 77 Comments: 0 Joined: 06/02/15	You might try these guys- worth a shot http://www.themarineconnection.net/rails.html
crabs63	#6  Posted on 04/12/18 - 11:15 AM
Member Posts: 8 Comments: 0 Joined: 11/20/06	max366, Thank you. I contacted http://www.themarineconnection.net/rails.html and no lucks. The search is still on.
EJO	#7  Posted on 04/13/18 - 8:21 AM
Member Personal Page Posts: 669 Comments: 6 Joined: 11/25/12	Being in CO apparently make it hard for you as I have several shops here that can easily duplicate/repair a SS railing like that polished and without any welds showing as that is a must in food service metal fabrication. Any good metal shop could do that. If you can't find anybody, find out shipping price to 49001 zip and I can find out for you or at least what is the diameter and overall length of the railing. Send that info including pictures of bend and other side in a PM and I'll get a quote for you. Skipper E-J m/v "Clumsy Cleat" a 2008 Montauk 150
Cvg	#8  Posted on 04/13/18 - 5:44 PM
Member Posts: 32 Comments: 0 Joined: 03/21/18	Agreed...good fabricator can weld and burnish out/ polish.... would never know it was repaired. Edited by Cvg on 04/13/18 - 5:46 PM