Before Posting, Please Read Our Posting Guidelines Below.
1. Use the full 4 digit year for everything you are asking your question about. Example: 1962, 1988, 2000, 2011 2. Include the correct name of your Whaler model. Example: Montauk 17, Montauk 170, Outrage 26, Outrage 260 3. Include the length when necessary. Example: 16, 17, 18, 20, 22 4. Do not post your email address anywhere on this site as it is already in your user profile.
Hey Fellers, what's the best way to git the paint of the inside of the hull? Is there a stripper that is gel coat friendly?
I will sand by hand some, much! But, would like to find an aggressive buffing wheel for my little orbital that will take the paint, but leave the gel. Is there such a disc?
Previous owner slathered on some resin with glass fabric. Guy covered the entire keel. There is a little rock damage that went through the gel coat. There are some hole in this job that are weeping water. My boat guy suggested I slap on some marine tech for the summer and fix this winter. The rest of the hull is OK. Any comments/helpful advice, Thanks
(corrected abbreviated year to full 4 digit year per guideline #1 at the top of this page)
Old Whale ah attached the following image:
[34.59Kb]
Edited by Joe Kriz on 07/25/17 - 11:41 AM
