1. Use the full 4 digit year for everything you are asking your question about. Example: 1962, 1988, 2000, 2011
2. Include the correct name of your Whaler model. Example: Montauk 17, Montauk 170, Outrage 26, Outrage 260
3. Include the length when necessary. Example: 16, 17, 18, 20, 22
4. Do not post your email address anywhere on this site as it is already in your user profile.

1964 13' transom adapter
ditchwich66	#1  Posted on 03/24/16 - 9:11 AM
Member Posts: 18 Comments: 0 Joined: 09/10/13	Has anyone had any luck with raising the transom to fit a 20" shaft motor? I was looking at the aluminum style from Kemtfab. I plan on re-powering the old girl and put new style steering cables also? Any feed back would be appreciated
tedious	#2  Posted on 03/24/16 - 9:28 AM
Member Personal Page Posts: 1072 Comments: 2 Joined: 09/07/08	Hi DW - if you put the string below into your favorite search engine it will point you to lots of information: transdapter site:www.whalercentral.com You could also try searching for kentfab. Good luck! Tim
Phil T	#3  Posted on 03/24/16 - 12:41 PM
Administrator Personal Page Personal Album Project Albums Posts: 7043 Comments: 6 Joined: 03/26/05	Instead of the adapter, you could install a mini jack plate to give you the added 5 inches. The boat would not be muddled, less cost and a DIY. The Kent Fabrications adapter is $435 Jackplate is $195 Bob's Machine Shop is well regarded by Whaler owners. Review this and give them a call and they can steer you in the right direction. http://www.bobsmachine.com/Mini-Manua...200100.htm Edited by Phil T on 03/24/16 - 12:45 PM