1. Use the full 4 digit year for everything you are asking your question about. Example: 1962, 1988, 2000, 2011
2. Include the correct name of your Whaler model. Example: Montauk 17, Montauk 170, Outrage 26, Outrage 260
3. Include the length when necessary. Example: 16, 17, 18, 20, 22
4. Do not post your email address anywhere on this site as it is already in your user profile.

Capacity plate location
Simple	#1  Posted on 03/23/15 - 10:58 AM
Member Posts: 7 Comments: 0 Joined: 04/12/14	Would anyone be able to direct me to the location of the capacity plate or decal location on my 1991 Guardian 19. I have found where the No Drill and Fuel Vent decals would go but no luck on the capacity decal or tag. I do see where there appears to have been 2 decals about 3 1/2 by 2 1/2 inches located 1 per side on the inside of the gunnel forward of the center console. What decal would have gone there? Thank you for the assistance.
Joe Kriz	#2  Posted on 03/23/15 - 11:24 AM
Site Owner Personal Page Personal Album Photo Albums Project Albums Posts: 11447 Comments: 452 Joined: 03/18/05	Not sure about the Commercial series hulls but the recreational hulls used aluminum plates held on with 4 rivets during that time frame. Here is one from a 1990-1995 Outrage 17' model. http://www.whalercentral.com/photogal...oto_id=839 These are mounted where you describe on either side depending on the year/model etc. Look for 4 possible rivet holes.
Simple	#3  Posted on 03/23/15 - 12:53 PM
Member Posts: 7 Comments: 0 Joined: 04/12/14	Thank you for the help Joe. There definitely aren't any holes as would be there if rivets had been used. But if there would have been 2 located as I mentioned, then I think that must be what was there. The use 2 of decals just surprised me.