1. Use the full 4 digit year for everything you are asking your question about. Example: 1962, 1988, 2000, 2011
2. Include the correct name of your Whaler model. Example: Montauk 17, Montauk 170, Outrage 26, Outrage 260
3. Include the length when necessary. Example: 16, 17, 18, 20, 22
4. Do not post your email address anywhere on this site as it is already in your user profile.

1990 Outrage 19' Bowrail dimensions and installation??
jackobl	#1  Posted on 03/22/14 - 9:35 PM
Member Posts: 2 Comments: 0 Joined: 03/15/14	I just bought a 1990 Outrage 19’ and it does not have the bow rail on it so I will purchase the stainless steel tubing, and the fittings and do it myself but I need to know the length and height of each section and the degrees of all the fittings. Can anybody help me with a diagram or specs of the bow rail? Thank you. (moderator note: a 1990 would be an Outrage 19', not an 18') Edited by Joe Kriz on 03/23/14 - 7:43 PM
W J Moody	#2  Posted on 03/23/14 - 6:57 PM
Member Posts: 20 Comments: 0 Joined: 02/07/08	I have a bow rail assembly off of a 1989 Outrage which is bowed slightly from being forced into a storage compartment, It is not kinked and could be easily reshaped. One piece welded with mounting plates.
Joe Kriz	#3  Posted on 03/23/14 - 7:44 PM
Site Owner Personal Page Personal Album Photo Albums Project Albums Posts: 11447 Comments: 452 Joined: 03/18/05	As I noted above in the Moderator Note: you have an Outrage 19'. http://www.whalercentral.com/userphot...album_id=5
W J Moody	#4  Posted on 03/24/14 - 1:11 PM
Member Posts: 20 Comments: 0 Joined: 02/07/08	My 1989 Outrage is an 18. Bow rail I guess would be same.
Joe Kriz	#5  Posted on 03/24/14 - 1:59 PM
Site Owner Personal Page Personal Album Photo Albums Project Albums Posts: 11447 Comments: 452 Joined: 03/18/05	Yes, late 1988 changed to the one piece/welded 1" stainless rails. Older rails had fittings and were 7/8" in diameter.
jackobl	#6  Posted on 03/30/14 - 8:50 AM
Member Posts: 2 Comments: 0 Joined: 03/15/14	Yes Joe, it is a 1990 18’6” outrage I. I was looking to make the bow rail out of 1” fittings and stainless steel piping but I need the height and length dimensions of each section or of the original bow rail so I can try and make it the same. WJMoody: Would you be interested in selling the bow rail you have and send it to me. Please consider and remember that I am currently in Honduras and shipping would be very expensive. Thanks for the help.
W J Moody	#7  Posted on 03/31/14 - 5:56 PM
Member Posts: 20 Comments: 0 Joined: 02/07/08	Would be glad to help but I think shipping expense would be out of this world as the rail is all one piece welded as originally installed on a 1989 Outrage. It is located in Corpus Christi Texas not far from Mexico.