1. Use the full 4 digit year for everything you are asking your question about. Example: 1962, 1988, 2000, 2011
2. Include the correct name of your Whaler model. Example: Montauk 17, Montauk 170, Outrage 26, Outrage 260
3. Include the length when necessary. Example: 16, 17, 18, 20, 22
4. Do not post your email address anywhere on this site as it is already in your user profile.

Building pilot bench for 1969 Eastport
Dggriffin369	#1  Posted on 02/21/14 - 10:48 AM
Member Posts: 17 Comments: 0 Joined: 10/18/13	Saw the drawings in downloaded are. There aren't any measurements for the support bracket. I was wondering if anyone knows them. Thanks (moderator note: changed abbreviated year to the full 4 digit year) Edited by Joe Kriz on 02/21/14 - 11:16 AM
Fitzgp	#2  Posted on 02/22/14 - 5:32 AM
Member Personal Page Posts: 33 Comments: 2 Joined: 08/09/07	Griff I just e-mailed a PDF file of the drawing sets (that you have) but I added in comments on the support drawing that show the dimensions that I used for my seats. Note, you will need to get creative on the curve of the support back and should use a compass to create the radius cuts. For the angles, if you print the support drawing, use a bevel gauge to measure the angle of what is on the drawing, and apply it to your material....it is the same even at a smaller scale. Good luck!