1. Use the full 4 digit year for everything you are asking your question about. Example: 1962, 1988, 2000, 2011
2. Include the correct name of your Whaler model. Example: Montauk 17, Montauk 170, Outrage 26, Outrage 260
3. Include the length when necessary. Example: 16, 17, 18, 20, 22
4. Do not post your email address anywhere on this site as it is already in your user profile.

norman pins
Tom Gannon	#1  Posted on 08/28/13 - 2:28 PM
Member Posts: 2 Comments: 0 Joined: 08/25/12	I'm reinstalling the aft norman pins on my 13' Whaler. I need to have measurements down from the top and in from the side so I drill in the right spot. I've filled and sanded and painted but neglected to measure when I orginally pulled them out. Anybody with a few minutes and a tape measure out there? Tom Gannon
Joe Kriz	#2  Posted on 08/29/13 - 5:14 PM
Site Owner Personal Page Personal Album Photo Albums Project Albums Posts: 11447 Comments: 452 Joined: 03/18/05	Tom, I don't have a 13' or I would measure it for you. Maybe when some of the 13' owners see this, they will help you.
CES	#3  Posted on 08/30/13 - 6:09 AM
Member Personal Page Photo Albums Project Albums Posts: 2681 Comments: 7 Joined: 04/27/07	f I remember, and no one beats me to it, I'll measure how far down my aft norman pins are for you. Cliff 1966 13' Sport with a 1993 40hp Yamaha 2 Smoker
Tom Gannon	#4  Posted on 09/25/13 - 5:48 AM
Member Posts: 2 Comments: 0 Joined: 08/25/12	Thanks. I just finished working on the bottom; I painted it with a 2 part epoxy after days of sanding. I'm about ready to turn her back over.
Tom W Clark	#5  Posted on 09/25/13 - 8:35 AM
Member Personal Page Posts: 4280 Comments: 7 Joined: 09/30/05	6" in and 1-1/2" down, to the center of the pins. Warning: There was quite a bit of variation. You can measure three different hulls and end up with three different sets of measurements,