1. Use the full 4 digit year for everything you are asking your question about. Example: 1962, 1988, 2000, 2011
2. Include the correct name of your Whaler model. Example: Montauk 17, Montauk 170, Outrage 26, Outrage 260
3. Include the length when necessary. Example: 16, 17, 18, 20, 22
4. Do not post your email address anywhere on this site as it is already in your user profile.

Grab Rail Kit
ironstone	#1  Posted on 02/01/12 - 6:53 PM
Member Personal Page Posts: 3 Comments: 1 Joined: 08/02/09	I am seeking actual dimensional data on the gunnel side grab rail kit. Can anyone provide dimensions for custom fabrication? The rail I am seeking is about as long as the boston whaler logo on the rear corner of the boat and approximately 6-7 inches tall. These are estimates and I need detailed dimensions. Thanks.
ritzyrags	#2  Posted on 02/03/12 - 5:26 AM
Member Project Albums Posts: 1003 Comments: 36 Joined: 06/18/08	Model and year of make would be a reasonable part of your question. Did your boat ever had such rails? Dont lie Dont Cheat And dont give up..
Joe Kriz	#3  Posted on 02/03/12 - 11:18 AM
Site Owner Personal Page Personal Album Photo Albums Project Albums Posts: 11447 Comments: 452 Joined: 03/18/05	See the new "Grab Rail Installation Instructions" in the downloads section. (contributed by ironstone and Boston Whaler) According to this Instruction sheet, this is for 18' to 25' models. As far as we know the length is 28 inches from center of fitting to center of fitting. This distance of course may vary slightly... http://www.whalercentral.com/photogal...oto_id=830 I never measured the height but they are not as tall as the Side Rails.... Side Rails are 6 1/2 inches tall so the Grab Rails are less than that. EDIT: My Side Rails are 6 1/2 inches to the bottom of the rail and 7 1/2 inches to the top of the rail approximately. Hopefully someone will measure theirs and give us the length and height... NOTE: Boston Whaler decals are 28 inches long for many Classic models.. http://www.whalercentral.com/photogal...hoto_id=48 Edited by Joe Kriz on 02/03/12 - 2:34 PM
ironstone	#4  Posted on 02/04/12 - 3:14 PM
Member Personal Page Posts: 3 Comments: 1 Joined: 08/02/09	Yea, I should have noted the model. I am working on a 1984 Outrage 18. My boat did not have the optional gunnel grab rails ...... thus my dimensional characteristic search in pursuit of having the grab rails reproduced. Based on what I have researched thus far, 28" in length relatively accurate based on length comparisons in from vintage whaler literature. I am still seek a good height dimension. Thanks in advance for any assistance. Ironstone