Posted by richtercom on 09/01/09 - 10:43 AM
#1
Any suggestions on mounting this unit to the curved transom of a 13 sport? I was thinking about using some wedge shaped washers between the unit and transom. This would allow 4 solid points of contact, I would then fill any gaps with a sealant. Should I be concerned that my 92 40 HP Evinrude will create too much stress on the transom because it is not sitting flush with the backside of the transom?
Posted by richtercom on 09/02/09 - 5:36 AM
#3
No, the top of my transom is level (no notch). From a bird's eye view of the hull, the transom is slightly curved from port to starboard.