Posted by drh146 on 12/12/22 - 10:17 AM
#1
I'd like to get a stainless plate made to go under the steering wheel, and house gauges and switches.
My boat is getting a new engine on, and I dont have it.
Does someone have (or could someone take) the measurements of the whole rectangle and size and location of the mounting screwholes please?
I would like the plate to replace the 2 black metals and 1 center vinyl one, as seen in the below picture from Phil's personal page. (Tried to attach)
Thank you!
Edited by drh146 on 12/15/22 - 11:00 AM
Posted by drh146 on 12/15/22 - 12:04 PM
#2
OK, i found the drawing of the plates in the downloads section (Thanks Joe K). Now all I need to know is the distance between the plates, or the distance between the inner mounting holes.. Also does anyone see any reason 1 full plate, instead of 2 with vinyl between, wouldnt work?
Thanks!
Posted by Phil T on 12/15/22 - 12:18 PM
#3
One plate has been done by a handful of owners with success.
I look at it as personal preference.