Posted by Dggriffin369 on 02/21/14 - 10:48 AM
#1
Saw the drawings in downloaded are. There aren't any measurements for the support bracket. I was wondering if anyone knows them. Thanks
(moderator note: changed abbreviated year to the full 4 digit year)
Edited by Joe Kriz on 02/21/14 - 11:16 AM
Posted by Fitzgp on 02/22/14 - 5:32 AM
#2
Griff
I just e-mailed a PDF file of the drawing sets (that you have) but I added in comments on the support drawing that show the dimensions that I used for my seats. Note, you will need to get creative on the curve of the support back and should use a compass to create the radius cuts. For the angles, if you print the support drawing, use a bevel gauge to measure the angle of what is on the drawing, and apply it to your material....it is the same even at a smaller scale.
Good luck!