---

Any of you guys has an idea of how the wiring for the nav lights is routed in the hull??

So far i have only found two leads on starboard side and will try them with the battery to see if it lights up both port and starboard nav lights.

Thanks in advance for your help....

---

Rob,

The wiring goes out through the starboard side and inside the rubrail to the starboard light.
The wires then continue to run around the bow of the boat to the port light.

It is easy to remove the rubrail insert if you leave it out in the sun. You don't have to take off the entire rubrail insert. Only remove it where you need to get to the wires.

For wiring the switch, see this article:
http://www.whalercentral.com/readarti...icle_id=51

---

As always Joe, you are there with your prompt response.....Thanks a lot, i will try removing the rubrail.