Posted by John Coryea on 06/15/12 - 1:38 PM
#1
Hello all-
Well I'm on my third mechanic..engine runs at high speed, low speed but wants to die in 2-3k range..priming it while dying, gets it going..he says he's getting 10 reading for vacuum..thinks it should be @ 15. oil side of vro works fine, compression equal on all four, and so far ,one carb removed and looks clean. Primer bulb does not collapse,remains hard.. new plugs,fuel filter clean..fresh non-ethanol gas..It will run all day above idle or wide open. Any ideas? Thanks,
John
Posted by Joe Kriz on 06/15/12 - 2:04 PM
#2
John,
You already have several ongoing post about this.
This is another duplicate post and will be deleted once you read this.
See your other post here that has many responses.
http://www.whalercentral.com/forum/vi...d_id=15004
Edited by Joe Kriz on 06/15/12 - 2:13 PM