Thread subject: Whaler Central - Boston Whaler Boat Information and Photos :: line chocks
Posted by 70katama on 11/30/11 - 4:09 PM
#1
hi all , I would like to install two line chocks on th bow of my 1970 katama. would place them a few [3 or 4] inches to port and starboard of the bow light. my concern is drilling into the bow light wire. i understand the wire is on port side behind the rub rail. can someone tell me where the wire is in relation to say the front edge of the rail ?i intend to keep the chocks as far back as I can , just want to be sure idont hit the wire. advice would be much appreciated. thanks
Posted by contender250 on 11/30/11 - 5:01 PM
#2
The wire goes straight down from the light fixture does a 90 degree turn to the rub rail and then follows the rub rail around the the back to the boat where it comes out
Posted by 70katama on 11/30/11 - 5:12 PM
#3
thanks contender250 , so i guess what your saying is if Ikeep the screws back an inch or so back from the back edge of the rub rail ill be ok ?
Posted by cwk6 on 11/30/11 - 5:30 PM
#4
From my understanding, the wire for the bow light actually runs within the rub-rail. As long as you are not drilling through the rub rail you should be fine.
Posted by Tom W Clark on 11/30/11 - 5:49 PM
#5
Bow light wiring only runs in the rub rail on those boats with the newer three piece Barbour rub rail, generally used after 1971.
A 1970 Katama and all the other 13s and 16/17s with the original one piece white rub rail had three wires molded into he hull itself. There were three so one could be used as a spare.
There is no way to replace those wires without finding a new route for it. You can retrofit the newer three piece rub rail or you can route it along the exterior of the hull just under the gunwale in the "finger grip". A single piece of white waterproof plastic tape will hold the wire in place and will be remarkably well hidden, though you do have to be mindful of it.
Posted by 70katama on 11/30/11 - 5:57 PM
#6
That is what i was unclear about . i knew the wire was there somewhere [ within the rail, in a slot behind it or.....?] t hanks to both you guys
Posted by 70katama on 11/30/11 - 6:13 PM
#7
Tom i do have the white rub rail still on the boat .now im wondering again, if molded in the hull, can i drill where i thought , about on inch or so behind the back edge of the rub rail .or is there a risk of hitting the wires .hope im not driving you all nuts with a non issue . thanks
Posted by 70katama on 12/01/11 - 4:22 AM
#8
tom Dawned on me that you meant the wire was run in the hull completly seperate of the gunwale . i guess i just had it in my mind the wire was near the rub rail . thanks for the new train of thought.
Posted by 70katama on 12/01/11 - 4:46 AM
#9
just found the thread from a couple weeks ago where Joe pointed out the same info ..as usual the info was here . i just didnt look in the right place. thanks to all for a great site