1. Use the full 4 digit year for everything you are asking your question about. Example: 1962, 1988, 2000, 2011
2. Include the correct name of your Whaler model. Example: Montauk 17, Montauk 170, Outrage 26, Outrage 260
3. Include the length when necessary. Example: 16, 17, 18, 20, 22
4. Do not post your email address anywhere on this site as it is already in your user profile.

1982 Outrage 18 throttle issue
Tom Glynn	#1  Posted on 10/17/15 - 3:14 PM
Member Posts: 37 Comments: 1 Joined: 10/01/15	The throttle lever for my 1982 outrage 18 (Mariner 125) wont stay in place. If I let go of it it drops back to lower speed. Has anyone had any experience with this? It is the single lever Mercruiser control with a button to put it in throttle only mode and the remote tilt button on the side of the lever.
Phil T	#2  Posted on 10/17/15 - 5:56 PM
Administrator Personal Page Personal Album Project Albums Posts: 7043 Comments: 6 Joined: 03/26/05	Tom - There is a friction adjustment screw inside the cover of the housing. Are you sure it is a Mercruser throttle and not a Mercury/Quicksilver model something like this: http://www.thehulltruth.com/attachmen...nnacle.jpg
Tom Glynn	#3  Posted on 10/17/15 - 8:13 PM
Member Posts: 37 Comments: 1 Joined: 10/01/15	I think that's it. I took the cover off but can't locate the screw. Any hints where it is? Thanks Tom
Tom Glynn	#4  Posted on 03/14/16 - 6:38 AM
Member Posts: 37 Comments: 1 Joined: 10/01/15	Phil, I'm Still looking for some advice on the problem of the throttle sliding back to idle when i let go. It does appear to be the Merc Quicksilver like the photo you show. Can you tell me where to look for the adj. screw when I take the cover off? Spring is coming and I really want to fix this. My mechanic couldn't find an adjustment and is suggesting a clamp on the cable?
Phil T	#5  Posted on 03/15/16 - 5:36 AM
Administrator Personal Page Personal Album Project Albums Posts: 7043 Comments: 6 Joined: 03/26/05	Tom There are several models of shifters. In all my research, the consensus is the friction adjustment is under the throttle arm. The install guide says to adjust friction before installation. I would unbolt/unscrew the shifter from the console (don't disconnect cables) and take a look at the bottom/underside.