1. Use the full 4 digit year for everything you are asking your question about. Example: 1962, 1988, 2000, 2011
2. Include the correct name of your Whaler model. Example: Montauk 17, Montauk 170, Outrage 26, Outrage 260
3. Include the length when necessary. Example: 16, 17, 18, 20, 22
4. Do not post your email address anywhere on this site as it is already in your user profile.

Whaler Decals
modenacart	#21  Posted on 11/06/09 - 2:36 PM
Member Personal Page Posts: 741 Comments: 4 Joined: 02/28/09	I have heard the same with Windex but have not tried it myself. They that give up essential liberty to obtain a little temporary safety deserve neither liberty or safety. --Benjamin Franklin
rbritdu	#22  Posted on 11/06/09 - 5:04 PM
Member Posts: 81 Comments: 3 Joined: 10/21/05	Hello , I have the No Smoking fuel vent stickers to put on . How is this done . Do I need to take the vent out and then put sticker on ??? How far down does the black or Red strip go below the gunnel ? I have these plus the don't drill stickers to put on. Any help I would appreciate . Thank you Bob 1979 V-22 Outrage, 225 HP Yamaha
ossnap	#23  Posted on 11/07/09 - 9:00 AM
Member Posts: 27 Comments: 0 Joined: 03/09/09	The original decals are 14 inches long on my '78 montauk. edit: placement 7 3/4" down to bottom of sled from under the gunwale lip 13 3/4" from transom to back of sled Edited by ossnap on 11/07/09 - 9:10 AM
theo	#24  Posted on 11/07/09 - 9:28 AM
Member Personal Page Posts: 252 Comments: 0 Joined: 08/26/08	1983 15' CC with 18" decals. 6 1/2" down to bottom of sled 11 1/2" from transom to back of sled Ted 1985 15' CC, 1994 60 hp Merc (Wednesday built), 5" jack plate
whalerman	#25  Posted on 11/07/09 - 1:47 PM
Member Posts: 540 Comments: 5 Joined: 06/26/07	rbritdu, the no smoking decal just cut the center out and place on hull, make sure that the hull is clean and free of wax in the location. The deck decals I used a hair dryer to remove the old decal and then cleaned the area with denatured alcohol and placed them according to location. Don't use the hair dryer at the gas vent!! Good luck. Not sure about the stripe, I'm guessing here -maybe an inch below the gun'l?? Edited by whalerman on 11/07/09 - 1:50 PM THOM : 1999 Outrage 18, 2012 E-TEC 150, 2012 EZ Loader trailer