---

Im trying to figure out how to wire a new bow light through a new 3 piece rub rail on a 1969 13' sport. Ive glassed in the old holes in the hull where the wire used to run (it couldn't carry a current). I have a few questions (Im sure the answer exists elsewhere so feel free to direct me there instead):

1. How do I wire the light so that I see the least amount of wire? In order for my bow light to sit flush the wires must run through the hull, do I just drill a hole down into the bow and than meet it horizontally through the rub rail and run the wire through there?
2. What wire should I buy to splice the light wire to? Is there a specific gauge I should use, or some good splice kit meant for the marine environment?
3. How do I exit the wire at the stern?
4. I want to use a classic 3 position switch for the bow and anchor light...how do I make the right connections to this switch and the battery?

Thanks for the help!