Posted by tedious on 05/31/16 - 2:24 AM
#46
CB, the key to the process is to remove the upper bolts and just loosen the lower ones, so the motor can slide in the slots.
If you have a floor jack, you can put it under the skeg to lift the motor.
If not, you can use the trailer jack to lift it - lower the jack all the way down, then put a block under the skeg to support the motor. Remove/loosen the bolts, then crank the jack up to lower the transom while the motor stays in place.
You'll need to re-caulk the bolt holes, but that's no big deal.
Tim