---

I'm looking for some advice on how to go about filling a rather large hole in my thru my splash well. The hole is about 1 3/4 x 4" deep. The previous owner ran the drain tube for the bilge through it rather than just running it over the back. Since it's mostly foam and not structural I was considering using some spray insulation can foam from Home Depot but I'm not sure if I will be able to get polyester resin or gelcoat to stick to it. Or should I fill with a large dowel?

There's also another hole in the transom, you can see there was an 1 1/2" piece of PVC there (possibly for some sort of drain) that I removed. I'm not sure if I can use a dowel for this or just fill with some Evercoat 27 and fiberglass....any suggestions?

Thanks!

Drain Tube installed
http://i880.photobucket.com/albums/ac7/ggalluppi/Whaler/A47B1E1F-E36C-46B9-84D1-09D8A244BFC3_1.jpg

Holes to be filled (bilge splash well)
http://i880.photobucket.com/albums/ac7/ggalluppi/Whaler/528752C3-E281-4F18-B995-2E782E7BDE17.jpg
http://i880.photobucket.com/albums/ac7/ggalluppi/Whaler/CD2DB9E3-0980-49AF-9969-FC256A307C4E.jpg

Transom hole
http://i880.photobucket.com/albums/ac7/ggalluppi/Whaler/C19ABDDF-A457-4BD4-BFAC-2C93AD33176D.jpg
http://i880.photobucket.com/albums/ac7/ggalluppi/Whaler/ABB979D5-FC53-483F-92A4-C4D5815F0F44.jpg