---

Where to start:

1. Remove and have prop shop dress edges of current Yam alum 13.5 x 15K prop and continue to experiment w/performance until break-in is complete?

1A. Remove and self dress [fine hand file] edges of current Yam alum 13.5 x 15K prop and continue to experiment w/performance until break-in is complete?

2. Do either of above, and upgrade hub to 'Flo-Torq II' system?

then later:

3. Replace same spec prop, but in SS?

or

4. Replace for SS with different specs [diam-pitch combo] based on full performance data [post break-in w/full equipment on board]?

Thanks for comments-suggestions.
Joe