Posted by ditchwich66 on 03/24/16 - 9:11 AM
#1
Has anyone had any luck with raising the transom to fit a 20" shaft motor?
I was looking at the aluminum style from Kemtfab. I plan on re-powering the old girl and put new style steering cables also?
Any feed back would be appreciated
Posted by tedious on 03/24/16 - 9:28 AM
#2
Hi DW - if you put the string below into your favorite search engine it will point you to lots of information:
transdapter site:www.whalercentral.com
You could also try searching for kentfab. Good luck!
Tim
Posted by Phil T on 03/24/16 - 12:41 PM
#3
Instead of the adapter, you could install a mini jack plate to give you the added 5 inches.
The boat would not be muddled, less cost and a DIY.
The Kent Fabrications adapter is $435
Jackplate is $195
Bob's Machine Shop is well regarded by Whaler owners. Review this and give them a call and they can steer you in the right direction.
http://www.bobsmachine.com/Mini-Manua...200100.htm
Edited by Phil T on 03/24/16 - 12:45 PM