Whaler Central - Boston Whaler Boat Information and Photos

Posted by seamac101 on 06/02/15 - 9:05 AM

can original nav wires be re-run? who sells white windshield gaskets? and last is there any mounting diagram for stern light placement? thanks, charlie

(changed abbreviated boat name from sak to Sakonnet for clarification)

Edited by Joe Kriz on 06/02/15 - 10:18 AM

Posted by seamac101 on 06/02/15 - 10:36 AM

The original wire is down in factory hole but not enough to grab. transom has been re-gelled not sure stern light mounts are in correct place. freshwater boat still has factory window seals want to replace thanks,charlie

Posted by Weatherly on 06/02/15 - 10:46 AM

For the window gasket material, look at this thread:

http://www.whalercentral.com/forum/vi...ost_123590

Posted by seamac101 on 06/02/15 - 10:48 AM

Should stern light mount straight up left to right or should it follow the angle of transom, being angled slightly to port. not forward/backwards angle side to side angle only. Just want to get it right

Posted by Joe Kriz on 06/02/15 - 11:05 AM

You will want to look in our Downloads section under Installation and Parts Breakdown Sheets and download the Stern Light Installation Instructions.
http://www.whalercentral.com/download...owstart=15

These lights were mounted on either the Stern or the Port side depending on the year.
Yours most likely is mounted on the Port side.

You can look at other Sakonnet models in the members personal page section.
http://www.whalercentral.com/viewpage...page_id=65

http://www.whalercentral.com/infusion...er_id=8412

Posted by seamac101 on 06/03/15 - 5:35 PM

Thanks Joe big help all the holes were in the right spot. Still wondering if i can pull a new nav wire through the factory run in the hull? does the old wire just run through the boat flotation material or does it have a dedacated run built into the hull? thanks again,Charlie

Posted by Phil T on 06/04/15 - 10:40 AM

#10

New wires for the bow navigation light should be run via the rubrail.

The original bow light wire is through the foam, no dedicated run.