Posted by Simple on 03/23/15 - 10:58 AM
#1
Would anyone be able to direct me to the location of the capacity plate or decal location on my 1991 Guardian 19. I have found where the No Drill and Fuel Vent decals would go but no luck on the capacity decal or tag. I do see where there appears to have been 2 decals about 3 1/2 by 2 1/2 inches located 1 per side on the inside of the gunnel forward of the center console. What decal would have gone there? Thank you for the assistance.
Posted by Joe Kriz on 03/23/15 - 11:24 AM
#2
Not sure about the Commercial series hulls but the recreational hulls used aluminum plates held on with 4 rivets during that time frame.
Here is one from a 1990-1995 Outrage 17' model.
http://www.whalercentral.com/photogal...oto_id=839
These are mounted where you describe on either side depending on the year/model etc.
Look for 4 possible rivet holes.
Posted by Simple on 03/23/15 - 12:53 PM
#3
Thank you for the help Joe. There definitely aren't any holes as would be there if rivets had been used. But if there would have been 2 located as I mentioned, then I think that must be what was there. The use 2 of decals just surprised me.