Posted by Beso21 on 05/12/14 - 5:32 PM
#1
Hope this is not a dumb question, but I am re-assembling the side rails for the boat and after completed all 4 post are not completely aligned. The 2 middle post are set inward compared to the 2 end post. I have aligned all set screw holes but this is the result. The rails are the original rails that I partially disassembled to clean up. Also I just received the base mounts form Specialty Marine but the screw holes on the new bases are to high and rail post will not sit flush on base mounts. Has anybody else ran into this problem? Thanks
Posted by Joe Kriz on 05/12/14 - 6:22 PM
#2
The rails only fit on one side due to the curvature of the hull.
Try switching the rails from one side to the other.