Whaler Central - Boston Whaler Boat Information and Photos

Thread subject: Whaler Central - Boston Whaler Boat Information and Photos :: norman pins

Posted by Tom Gannon on 08/28/13 - 2:28 PM

I'm reinstalling the aft norman pins on my 13' Whaler. I need to have measurements down from the top and in from the side so I drill in the right spot. I've filled and sanded and painted but neglected to measure when I orginally pulled them out.

Anybody with a few minutes and a tape measure out there?

Tom Gannon

Posted by Joe Kriz on 08/29/13 - 5:14 PM

Tom,

I don't have a 13' or I would measure it for you.
Maybe when some of the 13' owners see this, they will help you.

Posted by CES on 08/30/13 - 6:09 AM

f I remember, and no one beats me to it, I'll measure how far down my aft norman pins are for you.

Posted by Tom Gannon on 09/25/13 - 5:48 AM

Thanks. I just finished working on the bottom; I painted it with a 2 part epoxy after days of sanding. I'm about ready to turn her back over.

Posted by Tom W Clark on 09/25/13 - 8:35 AM

6" in and 1-1/2" down, to the center of the pins.

Warning: There was quite a bit of variation. You can measure three different hulls and end up with three different sets of measurements,